Brainz 38592 Instruction Manual

PLEASE READ THE INSTRUCTIONS CAREFULLY

What you need

•
DC5V/USB Cable (included)
•
Mobile phone, tablet, or laptop with Bluetooth (not included)
•
TF/SD Card (optional, not included)

How to charge the LED Speaker

Insert the provided DC5V cable into the back of the LED speaker and connect the USB end to a power source.
When you do this, your product will charge.

How to set up the device

Press and hold the button at the top of the speaker with the power symbol for 3 seconds to turn on the speaker.
The speaker will appear under your new Bluetooth connections on your device as BRAINZ S100. By clicking on it,
your phone will connect, and the speaker will be ready for use.
Volume
To increase the volume, press and hold the + button on the top of the speaker. To decrease the volume, press
and hold the - button.
Next/previous track
Press the + button once to go to the next track. Press the - button once to go to the previous track.
Change color
Press the 'M' button once to change the color of the LED speaker.
Switching between modes
Hold the 'M' button for 3 seconds to switch between modes (Bluetooth, SD/TF, or USB).
USB
You can play your own music through the USB port. Insert a USB flash drive into the designated access port of
the LED Speaker.
TF/SD
It is possible to play music with your own SD card. Insert your SD card into the 'TF' port.
Phone holder
The LED Speaker also serves as a phone holder. To do this, move the handle to the back and place your phone
in the designated slot at the top of the LED speaker.

Turning off

Press and hold the button at the top of the speaker with the power symbol for 3 seconds to turn off the speaker.

Note:

Do not use a charger with a higher voltage than what is suitable for this product.
For more information about this product, please visit
BRAINZ TUNES LED SPEAKER
INSTRUCTION MANUAL
AND KEEP THEM FOR FUTURE REFERENCE
This manual is valid for article number 38592.
EN
www.brainz-electronics.nl