Brainz LENN Instruction Manual

What you need
•
USB-C Cable (included)
•
USB Adapter or USB Power Supply (not included)
•
Bluetooth-enabled mobile phone, tablet or laptop (not included)
•
TF/SD Card (optional, not included)
How to charge the speaker
Connect the supplied cable to the speaker and plug the USB side into a power source. The speaker is charging when
you see a red light on. When the speaker is fully charged, this red light will turn off.
How to set up the device
Make sure the speaker is fully charged before using it. Turn the speaker on by flipping the slider on the back of the
speaker. The speaker will appear under the new Bluetooth connections on your device as 'BRAINZ S155'. Clicking on
this will connect your device and the speaker will be ready to use. The speaker will let you know if your device is
connected by sound.
Volume
Press and hold the + button to increase the volume. To turn the volume down, press and hold the - button.
Is the music a bit soft at the highest volume? Make sure the volume on your device is also set to maximum.
Pause music
Briefly click the M button to pause the music. Repeat to resume the music.
Next/previous number
To go to the previous number, briefly click the - button. To go to the next song, briefly click the + button.
Switching the mode
Short press the M button to switch between bluetooth and TF/SD.
TF/SD
It is possible to play music using your own SD card. Insert your SD card into the 'TF' port.
Switch off
To turn off the speaker, flip the slider.
Caution:
Do not use a charger with a higher voltage than suitable for this product.
For more information about this product, please visit
BRAINZ SPEAKER LENN BLUE
INSTRUCTION MANUAL
PLEASE READ THE INSTRUCTIONS CAREFULLY
AND KEEP THEM FOR FUTURE REFERENCE
This manual is valid for article number 38631.
EN
www.brainz-electronics.nl