Brainz 38593 Instruction Manual

BRAINZ WOOFER SPEAKER WHEATSTRAW
PLEASE READ THE INSTRUCTIONS CAREFULLY

What you need

•
DC5V/USB Cable (included)
•
AUX Cable (optional, not included)
•
Mobile phone, tablet, or laptop with Bluetooth (not included)
•
TF/SD Card (optional, not included)

How to charge the Woofer speaker

Connect the provided cable to the speaker and plug the USB end into a power source. Once you've done this, a
red light will start glowing. This indicates that the speaker is charging. The speaker is fully charged when the light
on the speaker goes out.

How to set up the device

Turn on the speaker by sliding the 'Power' button to 'On.' The speaker will appear among your new Bluetooth
connections on your phone as BRAINZ Speaker S30. Click on it to connect your phone, and the speaker is ready
for use.
Volume
To increase the volume, press and hold the + button on the top of the speaker. To decrease the volume, press
and hold the - button.
Switching between modes
Hold the 'M' button for 3 seconds to switch between modes (Bluetooth, USB, AUX, or SD/TF).
USB
You can play your own music through the USB port. Insert a USB flash drive into the designated access port of
the Woofer speaker.
AUX
To use the AUX port, insert one end of your AUX cable into your phone and the other end into the 'AUX' port of
the speaker (this cable is not included). The speaker will automatically switch to AUX mode and turn off Bluetooth.
SD
It's possible to play music with your own SD card. Insert your SD card into the 'TF' port.
Turning off
You can turn off the speaker by sliding the 'Power' button to 'Off.'
Note:
Do not use a charger with a higher voltage than what is suitable for this product.
For more information about this product, please visit
INSTRUCTION MANUAL
AND KEEP THEM FOR FUTURE REFERENCE
This manual is valid for article number 38593.
EN
www.brainz-electronics.nl