Brainz 38599 Instruction Manual

PLEASE READ THE INSTRUCTIONS CAREFULLY
What you need
•
DC5V/USB Cable (included)
•
Mobile phone, tablet, or laptop with Bluetooth (not included)
•
TF/SD Card (optional, not included)
How to charge the Disco Speaker
Connect the provided DC5V cable to the back of the Disco speaker and plug the USB end into a power source.
Once you've done this, the speaker will start charging.
How to set up the device
The speaker can be used as a Bluetooth speaker. Hold the On/Off button on the top of the speaker for 3 seconds
to turn the speaker on. When you want to use a Bluetooth connection, open the Bluetooth menu on your device
and search for 'BRAINZ S125'. Click on it and wait for your device to give a notification that it's connected to the
speaker.
Volume
To increase the volume, press and hold the + button on the back of the speaker. To decrease the volume, press
and hold the - button.
Pause music
Press the On/Off button once to pause the music. Repeat this to resume the music.
Adjusting LED lighting
The LED lighting on the Disco Speaker has three modes. To switch between modes, double-click the 'M' button.
Mode 1: Slow disco lighting
Mode 2: Fast disco lighting
Mode 3: Disco lighting off
Next/Previous track
Press the + button once to go to the next track. Press the - button once to go to the previous track.
Switching between modes
Press the 'M' button to switch between modes (Bluetooth, SD/TF, or USB).
USB
Through the USB port, you can play your own music. Insert a USB flash drive into the designated access port of
the Disco speaker.
TF/SD
It's possible to play music with your own SD card. Insert your SD card into the 'TF' port.
Note:
Do not use a charger with a higher voltage than what is suitable for this product.
For more information about this product, please visit
BRAINZ DISCO SPEAKER
INSTRUCTION MANUAL
AND KEEP THEM FOR FUTURE REFERENCE
This manual is valid for article number 38599.
EN
www.brainz-electronics.nl