Brainz 38594 Instruction Manual

PLEASE READ THE INSTRUCTIONS CAREFULLY

What you need

•
USB-C Cable (included)
•
USB Cable (optional, not included)
•
Mobile phone, tablet, or laptop with Bluetooth (not included)

Charging the Disk Speaker

Insert the included USB-C cable into the bottom of the disk speaker and connect the USB end to a power source.
When you do this, your product will begin to charge.

Setting up the device

Hold down the button at the top of the speaker with the power symbol for 3 seconds to turn on the speaker. The
speaker will appear among your new Bluetooth connections on your phone as BRAINZ S105. By clicking on it,
your phone will establish a connection, and the speaker is ready for use.

Volume

To adjust the volume higher or lower, you can use the dial knob located on the top of the Disk speaker.

Next/previous song

Press the + button once to skip to the next track. Press the – button once to go to the previous track.

USB

You can play your own music via the USB port. Insert a USB stick into the designated access port on the Disk
speaker.

Mode

Press the 'M' button to switch the Disk speaker from Bluetooth mode to USB mode.

Turning Off

Hold down the button at the top of the speaker with the power symbol for 3 seconds to turn off the speaker.

Note

Do not use a charger with a higher voltage than what is suitable for this product.
For more information about this product, please visit
BRAINZ DISK SPEAKER
INSTRUCTION MANUAL
AND KEEP THEM FOR FUTURE REFERENCE
This manual is valid for article number 38594.
EN
www.brainz-electronics.nl