Table of Contents
Advertisement
SUN2000-(125KTL-M5, 200KTL-H4, 250KTL-H0,
286KTL-H0)
User Manual
● The cable outer diameter can be measured using the ruler sticker in the
maintenance compartment.
● Remove the rubber rings according to the cable diameter range, and ensure
that the crimping module is not damaged. Otherwise, the protection level of
the device will be affected.
● Ensure that the cable jacket (if any) is in the maintenance compartment.
● Ensure that the AC power cables are connected securely. Otherwise, the inverter
may fail to operate, or become overheated during operation due to an
unreliable connection, which will damage the terminal block.
● Do not pull the cables horizontally after they have been secured, as this may
damage the wiring terminals.
Step 1 Prepare cables by referring to
Step 2 Remove rubber rings according to the cable diameter range. Use scissors to cut off
the joints of the rubber rings to remove them. Remove all rubber rings in the
same way.
Figure 5-11 Removing a rubber ring
Step 3 Connect the AC power cables to the terminal block and ensure that the cables are
securely connected.
●
Issue 04 (2023-09-22)
NO TICE
Single-core cable scenario
Copyright © Huawei Technologies Co., Ltd.
A Crimping an OT or DT
5 Connecting Cables
Terminal.
46
Advertisement
Table of Contents
