Sapido IPJC1n User Manual page 83

Chapter 6.Q & A
Why can't preview camera image via browse in GUI?
•
A:User needs to setup the VLC(
computer.
Where can I get the record image of camera?
•
A:If user save record image in USB disk of IPJC1.Go to "webcam" folder find
it.
Where is the XDSL Router installed on the network?
•
A:In a typical environment, the Router is installed between the XDSL line and
the LAN. Plug the XDSL Router into the XDSL line on the wall and Ethernet
port on the Hub (switch or computer).
Why does the throughput seem slow?
•
A:To achieve maximum throughput, verify that your cable doesn't exceed 100
meter. If you have to do so, we advise you to purchase a bridge to place it in
the middle of the route in order to keep the quality of transmitting signal. Out
of this condition you would better test something else.
◦ Verify network traffic does not exceed 37% of bandwidth.
◦ Check to see that the network does not exceed 10 broadcast messages
per second.
◦ Verify network topology and configuration.
Why doesn't IPJC1 power up?
•
A:Check if the output voltage is suitable, or check if the power supply is out
of order.
The Internet browser still cannot find or connect to IPJC1 after verifying the IP
•
address and LAN cable, the changes cannot be made, or password is lost.
A:In case IPJC1 is inaccessible; you can try to restore its factory default
settings. Please press the "Reset" button and keep it pressed for over 7
seconds and the light of STATUS will vanish. The LEDs will flash again when
reset is successful.
Why does IPJC1 shut down unexpectedly?
•
A:Re-plug your power adapter. Then, check the STATUS indicator; if it is off,
the internal flash memory is damaged. For more help, please contact with
your provider.
What is the default IP address of the router for LAN port?
•
A:The default IP address is 192.168.1.1 with subnet mask 255.255.255.0
VLC media player )
plug-in package in