Settings Button - Redback A 4460 Operating Manual

Redback A 4460 4 x 8 Stereo Switcher
®
MASTER WALLPLATE OPERATION
The master wallplate or paging console connects to the controller via Cat5e UTP or similar cabling and can be located up
to 300m away. Up to two plates (master or zone) can be connected on a single cable run, with a maximum of 8 wallplates
per system.
The master wallplate allows for audio source selection and level control for every output zone. The left side of the screen
displays the output zones with the custom zone labels you have selected in section 7.0. Below the name, the chosen audio
source and volume level is displayed.
To make changes, tap the output zone you desire on the left and use the volume slider, volume +/- buttons or on/off selec-
tor to make adjustments to the mixed audio output in that zone.
For example, if you wanted to turn the "MP3" on in "Function RM1", you would tap the "Function RM1" output zone on
the left, then press "MP3" button to select that source. The source will change colour indicating it is switched on, and the
volume will be set to the last used setting.
To adjust the colour theme, tap the three lines icon on the top left of the screen. See section 11.0 for information on wall-
plate settings.
To make system wide changes to audio sources, select "SYSTEM" on the left hand side of the screen and then select the
audio source and volume level you wish to play in all zones connected to the system.
10.0 ZONE WALLPLATE OPERATION
1

Settings Button

Tap this to access zone wallplate settings ie: to adjust wall
plate colour theme and backlight settings.
2 Audio Source Selection Buttons
Use these buttons to select the audio source required for the
zone you are located in.
3 Global Input Source Selection
Allows the user to select the global input which is a bluetooth
audio streaming device which is made available to all zones in the
system.
4 Volume Control Area
Use these buttons to make adjustments to level control and
mute audio. When muting is turned off, volume level returns
to last chosen setting.
5 Output Zone Name
The name of the output zone.
6 Bluetooth Audio Status
When selected the BT function will enable allowing you to connect audio streaming from your chosen device. This
button changes colour to display as the active source when connected.
The zone wallplate connects to the controller via Cat5e UTP or similar cabling and can be located up to 300m away. Up to
two plates (master or zone) can be connected on a single cable run, with a maximum of 8 wallplates per system.
The zone wallplate allows for audio source selection and level control for the zone in which its located. To make changes,
simply tap the volume +/- buttons or switch an audio source on or off using the on/off selector. When an audio source is
switched off, the controls will display in a darker colour.
To adjust the colour theme, tap the three lines icon on the top left of the screen. See section 11.0 for information on wall-
plate settings.
8 Redback® Proudly Made In Australia
1
8.00am
Input Selection
2
IPHONE
RADIO MIC
3 Global Input
RECEPTION FUNCTN RM1
Volume Control
4
Vol
63%
Fig 4
www.redbackaudio.com.au
5
FUNCTN RM1
FOXTEL
MP3
BT Audio
6
Vol+
Vol-
Mute