Table of Contents
Advertisement
Redback
A 4460 4 x 8 Stereo Switcher
®
12.0 APP OPERATION
iOS/Android app under development. The app will connect to the local zone wallplate via Bluetooth and allow adjustments
of source and level control in that zone.
13.0 DIP SWITCH SETTINGS
The A 4460 has 1 set of DIP switches with the following settings.
DIP 1
Switch 1
OFF: MP3 play trigger momentary to play MP3 until end.
ON: MP3 play trigger hold to play MP3. Release to stop.
Switch 2
Not Used.
Switch 3
Not Used.
Switch 4
OFF: Battery back up for clock off.
ON: Battery back up for clock on.
New settings will be effective when power is switched back on.
14.0 FIRMWARE UPDATE
It is possible to update the A 4460 firmware by downloading updated versions from www.altronics.com.au or
redbackaudio.com.au. To perform an update, follow these steps.
1. Download the Zip file from the website.
2. Remove the Micro SD card from the A 4460 and insert it into your PC.
3. Extract the contents of the Zip file to the root folder of the SD Card.
4. Rename the extracted .BIN file to update.BIN.
5. Remove the SD card from the PC following windows safe card removal procedures.
6. With the power turned off, insert the SD card back into the A 4460.
7. Turn power on to the A 4460. The unit will check the SD card and if an update is required the A 4460 will perform the
update automatically.
For updating firmware on wallplates (A 4461, A 4462, A 4463, A 4464), each plate needs to be individually updated.
RJ45 cabling configuration for system components (568A 'Straight through')
System components are connected using "pin to pin" configuration RJ45 data cabling as shown below. When installing
ensure all connections are verified with a LAN cable tester before switching any system component on.
Failure to follow the correct wiring configuration may result in damage to system components.
1 TX+
568A
2 TX-
3 RX +
Straight Through
4
(both ends)
5
6 RX-
Pins Face Upwards
7
8
10
Redback® Proudly Made In Australia
IMPORTANT NOTE:
Ensure power is switched off when adjusting DIP switches.
8
7
6 RX-
5
4
3 RX +
2 TX-
1 TX+
www.redbackaudio.com.au
Advertisement
Table of Contents
