Table of Contents
Advertisement
1. 4 How do I create G-code?
To create G-code you need a program that allows you to create a 2D or 3D file. This file contains the geometry of the
workpiece to be cut. In general you can create this with 2D or 3D drawing software. You then need a program to
convert the geometry into a G-code that the machine can read. Sometimes both processes can be performed with
the same program. Check out our site for the possibilities
2. Safety regulations
2.1 Basic principle of safety in the workplace
Most accidents occur because safety regulations are not taken into account or are ignored. Safety equipment
such as shields, safety glasses, dust masks, hearing protection, etc. reduce the risk of accidents. But even the
best safety measures provide no protection in the event of poor judgment, inattention or carelessness. Pay
attention at all times in the workshop and use common sense. If something seems too dangerous, don't try it,
but find a safer solution, even if it may take more time. Remember: your personal safety is your own
responsibility.
The user of the machine must be sure of the following:
Persons operating the machine have received instructions/training and have been made aware of the dangers and
safety regulations.
The safety regulations are complied with and can preferably be read at the workplace. For this reason, the manual
is part of the machine and must be kept within easy reach of the machine at all times. When the machine is resold,
the manual must be handed over!
2.2 Basic safety regulations for working with machines
1.
Make sure you understand this manual before using the machine. Failure to follow this instruction may
result in serious personal injury, property damage and/or damage to the machine.
2.
Make sure you have read and understood all warnings in this manual and those marked on the
machine. Failure to follow these warnings could result in serious personal injury.
3.
Replace warning labels when they are no longer readable or have been removed.
4.
This machine is designed and intended for use by professionals and experienced
staff. If you are not familiar with how to use the machine, do not use it until you have gained sufficient
experience and knowledge.
5.
Do not use this machine for purposes other than those for which it is intended. If this does happen or if
the machine is modified, the warranty will be void and the manufacturer will not be liable for any
damage or injury caused as a result.
6.
Always use ANSI approved safety glasses or face mask when operating this machine.
7.
Do not wear jewelry, loose clothing and/or watches while using the machine, as these can get caught in
loose parts. Long hair should be tied back or put in a hairnet. Wearing non-slip footwear or applying anti
-slip strips to the floor is recommended.
8.
Do not use this machine when you are tired or under the influence of
alcohol/medicines/drugs.
9.
Check that the main switch is in the 0 position (OFF) before connecting the machine to the power
supply.
https://www.pritec-automation.com
3
Advertisement
Table of Contents
