Control Panel (Basic Elements) - PRITEC ACROS 80S Manual

10. Control panel (basic elements)

1. Cutting path display - This shows the cutting path of the loaded G-code file.
2. ''TORCH'' on/off - This turns the arc of the plasma cutter on and off.
3. ''JOG'' controller X/Y – By clicking on the arrows you can control the X and Y axes.
4. ''JOG'' controller Z – By clicking on the arrows you can control the Z axis.
5. ''RESET'' – To unlock, stop or reset the system.
6. ''PLAY'' – Starts playback of the loaded G-code file.
7. ''PAUSE'' – Allows you to pause the cutting process and then resume it by clicking ''play''.
8. "STOP'' – Stops the cutting process. By clicking ''play'' again, the cutting process starts all over again.
9. Open G-code file – This opens the desired G-code file.
10. G-code display – The G-code is displayed here line by line.
11. ''HOME'' – This sets the X, Y and Z axes to zero to create a ''HOME'' point.
12. ''MODE'' – In this menu you can switch between continuous (CONT) and step mode (INCR). When you
enable continuous mode, you can control the X, Y or Z axis uninterruptedly. In step mode, the X, Y or Z axis
will move to the set ''INCREMENTS'' value by control.
13. ''FEED'' – Here you can control the speed or manually override it by clicking on the arrows. When you click
on the reset button between the arrows, the original set value will appear again.
14. ''SOFT LIMITS'' – When you have determined the ''HOME'' position of the machine and then enable this
function, the machine will not go outside the set table margins.
15. ''GO HOME'' When you have determined the correct ''HOME'' position, and the soft limits are enabled, by
clicking on the icon you can automatically send the machine to its ''HOME'' position. (as described in 7.1
Homing)
23