Installing A Type-O Storage Controller - Hitachi HA815 G3 Series User Manual

Installing a type-o storage controller

Prerequisites
Before performing this procedure, verify that you have the following items available:
• Compatible controller cables (P58075-001/P58076-001)
• Phillips No. 1 screwdriver
About this task
CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other
static-sensitive devices. To prevent damage, observe antistatic precautions.
CAUTION: The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not
operate the server when a port blank is removed without the corresponding I/O port option installed.
Procedure
1. Power down the server.
2. Remove the server from the rack.
3. Do one of following:
a. Remove the PCI slot blank.
b.
Remove the secondary riser
4. Remove the OCP slot blank:
a. Remove the blank screw (callout 1).
b. Use a plastic spudger to pry the top side of the blank from the chassis (callout 2).
c. Remove the blank (callout 3).
Retain the screw and blank for future use.
5. Install the type-o storage controller:
cage.
Hardware options installation 71