Table of Contents
Advertisement
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Slide the controller into the bay until it clicks into place (callout 2).
Make sure that the controller is seated firmly in the slot.
c. Rotate the locking pin to the close (horizontal) position (callout 3).
6. Cable the type-o storage controller.
7. (Optional) If the controller cable is not yet connected to the front SFF drive backplane:
a. Remove the fan cage.
b. Cable the MR type-o storage controller.
8. To configure the controller, see the relevant storage controller guide.
The installation is complete.
Hardware options installation
72
Advertisement
Table of Contents
