Table of Contents
Advertisement
en Installation instructions
Note:
The accessories supplied may differ depending on the
appliance model.
¡ The gas connecting piece may vary depending on
the gas type and the country-specific regulations.
¡ To determine the correct nozzle diameter, check the
→ "Technical data – Gas", Page 42 table.
¡ Always use a new seal.
¡ (*) Never establish a gas connection without these
parts.
Explanation
Bypass nozzle
Burner nozzle
(*) Seal
(*) Connecting piece for nat-
ural gas (NG: G20, G25)
¡ TS 61-210 EN 10226 R½
¡ EN 10226 R½
(*) Connecting piece for nat-
ural gas (NG: G20, G25)
¡ TS EN ISO 228 G½
¡ EN ISO 228 G½
(*) Connecting piece for liquid
gas (LPG: G30, G31)
Connecting piece
Blind plugs (closure part)
Replacing the cooker burner nozzles
Switch off all of the knobs on the control panel.
1.
Close the gas connection shut-off.
2.
Remove the pan support grids or the pan support
3.
racks and the burner parts.
Use the socket wrench 7 to remove the cooker
4.
burner nozzles.
38
If your appliance features a wok burner with side ac-
5.
cess, remove the burner nozzle as shown below.
7
Look up the burner nozzles in the table. You can
6.
find additional information about this in the section
entitled
→ "Technical data – Gas", Page 42.
Fit the new nozzles into the appropriate burners.
‒
After replacing the nozzles, check that there are no
7.
leaks. You can find additional information about this
in the section entitled "Leak and function test"
→ Page 41.
Adjusting or replacing bypass nozzles (small
flame setting)
You can set the minimum flame height for the burners
via the bypass nozzles.
Requirements
¡ Close the gas isolating equipment.
¡ Disconnect the appliance from the power supply.
Switch off all of the knobs on the control panel.
1.
Remove the knobs one by one by holding them
2.
tightly against the control panel and pulling them to-
wards you slightly.
7
Advertisement
Table of Contents
