Table of Contents
Advertisement
en Installation and connection
¡ The appliance is designed for operation at 220-240
V. 16 A fuse
¡ Any damage arising from the appliance being con-
nected incorrectly will invalidate the warranty.
CAUTION ‒ !
The power cable may be damaged. The damage to the
power cable may lead to a dangerous situation.
The power cable must be replaced by the manufac-
▶
turer, their after-sales service or a similarly qualified
person.
¡ The appliance must always be disconnected from
the power supply when installation work is being
carried out.
¡ The appliance fulfils the requirements of protection
class I and must only be connected to an earthed
mains socket.
¡ The mains power cable must be at least type H05 V
V-F 3G 1 mm².
4.4 Appliance categories
Country
RU, BY, KZ, AM, KG
UA
MA
AE, LB, JO
EG
4.5 Setting up the appliance
Place the appliance on a smooth surface.
Never set up the appliance behind a decorative door or
the door of a kitchen unit. There is a risk of overheat-
ing.
¡ Install the appliance in accordance with the spe-
cified dimensions.
¡ The distance between the top edge of the cooker
and the bottom edge of the extractor hood must
meet the requirements of the extractor hood manu-
facturer.
¡ Ensure that the appliance is not moved again after it
is set up.
¡ In particular, the distance from the high-output
burner or wok burner to the fronts of adjacent units
or from the wall must be at least 50 mm.
10
Important information about the electrical
connection
Note the following information and ensure that:
There is a risk of electric shock if you touch live com-
ponents.
▶
▶
▶
¡ Fit the mains plug and socket together.
¡ The mains plug can be accessed at all times.
¡ The cross section of the cable is sufficient.
¡ The mains cable is not kinked, crushed, modified or
¡ If required, the mains cable must only be replaced
¡ Do not use any multiple plugs or multi-connectors
¡ The earthing system is correctly installed.
¡ If using a residual current device, only use one that
¡ The mains cable does not come into contact with
Category
II 2H3B/P
II 2H3B/P
I 3+
II 2H3B/P
II 2H3+
Positioning and levelling
Positioning the appliance
When installing the appliance, ensure that the final loc-
ation has sufficient space that the appliance can be
pulled out for cleaning and maintenance work.
The ground must be hard and stable. The wall directly
behind the appliance must be made of non-flammable
material, such as tiles.
If you have to pull the appliance while positioning it, en-
sure that the adjustable feet are screwed in tightly.
Aligning the appliance
Aligning the appliance
Information
1
2
3
WARNING ‒ Risk of electric shock!
Hold the mains plug with dry hands only.
Never pull out the mains plug from the socket while
the appliance is in operation.
Pull out the power cable directly at the plug and
never by pulling the power cable as this may be-
come damaged.
severed.
by a qualified electrician. A replacement mains
cable is available from the after-sales service.
and extension cords.
bears the mark
. The presence of this mark is the
only way to be sure that it fulfils all the applicable
regulations.
heat sources.
P (mbar)
2000 тта–3000 тта
20 - 28 - 30
28 - 30/37
20 - 28 - 30
20 - 28 - 30/37
Yellow + green
Brown
Blue
Advertisement
Table of Contents
