Integrated Peripherals Page - PCchips M787CLR User Manual

Mainboard User's Manual

Integrated Peripherals Page

This page sets some of the parameters for peripheral devices
connected to the system.
On-Chip IDE Channel0
On-Chip IDE Channel1
IDE Prefetch Mode
Primary Master PIO
Primary Slave PIO
Secondary Master PIO
Secondary Slave PIO
Primary Master UDMA
Primary Slave UDMA
Secondary Master UDMA
Secondary Slave UDMA
Init Display First
Onboard FDD Controller
Onboard Serial Port 1
Onboard IR Port
x UART 2 Mode
x IR Function Duplex
x TX,RX inverting enable
Onboard Parallel Port
On-Chip IDE Use these items to enable or disable the PCI IDE
channels that are integrated on the mainboard.
Channel 0,1
Primary/
Each channel supports a master device and a
slave device. These four items let you assign
Secondary Master/
which kind of PIO (Programmed Input/Output) is
Slave PIO
used by IDE devices. You can choose Auto, to let
the system auto detect which PIO mode is best, or
you can install a PIO mode from 0-4.
Primary/ Each channel supports a master device and a
slave device. This motherboard supports
Secondary Master/
UltraDMA and provides faster access to IDE
Slave UDMA
devices. If you install a device that supports
UltraDMA, change the appropriate item on this list
to Auto. You may have to install the UltraDMA
driver.
Init Display First Use this item to define if your graphics adapter is
installed in one of the PCI slots or select Onboard
if you have a graphics system integrated on the
24
Integrated Peripherals
Enabled
Enabled
Disabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
PCI Slot
Enabled
3F8/IRQ4
Disabled
Standard
Half
No, Yes
378/IRQ7
Item Help
Menu Level