PCchips M787CLR User Manual page 32

Mainboard User's Manual
MODEM Use IRQ
If you want an incoming call on a modem to
automatically resume the system from a power-
saving mode, use this item to specify the interrupt
request line (IRQ) that is used by the modem. You
might have to connect the fax/modem to the
mainboard Wake On Modem connector for this
feature to work.
Soft-Off by
Under ACPI (Advanced Configuration and Power
management Interface) you can create a software
PWRBTN
power down. In a software power down, the
system can be resumed by Wake Up Alarms. This
item lets you install a software power down that is
controlled by the normal power button on your
system. If the item is set to Instant-Off, then the
power button causes a software power down. If
the item is set to "Delay 4 Sec." then you have to
hold the power button down for four seconds to
cause a software power down.
State After Power
Use this item to set a system power state when
power restores after sudden AC power loss.
Failure
Keyboard Power Use this item to enable or disable the keyboard
power on function.
On
Wake Up Events
This item opens a submenu that enables you to
set events that will resume the system from a
power saving mode. Select Wake Up Events and
press Enter to display the following items: VGA,
LPT & COM, HDD & FDD, PCI Master, PowerOn
by PCI Card, Wake Up On LAN/Ring, RTC Alarm
Resume, Primary INTR, and IRQs Activity
Monitoring.
28