Installing Add-On Cards - PCchips M922LR V1.1 Manual

configure the floppy diskette drives that you have installed.

Installing Add-on Cards

This mainboard has four 32-bit PCI (Peripheral Components Interconnect)
expansion slots, one 4xAGP slot, and one CNR slot.
PCI Slots PCI slots are used to
install expansion cards
that have the 32-bit
PCI interface.
4xAGP The 4xAGP slot is used
Slot to install a graphics
adapter that supports
the 4xAGP specifica-
tion and has a 4xAGP
edge connector.
CNR Slot This slot is used to
insert CNR cards with
Modem and Audio
functionality.
Note: Before installing an add-on card, check the documentation for the card
carefully. If the card is not Plug and Play, you may have to manually con-
figure the card before installation.
Follow these instructions to install an add-on card:
1. Remove a blanking plate from the system case corresponding to the slot you
are going to use.
2. Install the edge connector of the
add-on card into the expansion
slot. Ensure that the edge con-
nector is correctly seated in the
slot.
3. Secure the metal bracket of the card to the system case with a screw.
Note: For some add-on cards, for example graphics adapters and network adapters,
you have to install drivers and software before you can begin using the add-on
card.
16