Chapter 3: The Radio; Listening To The Radio - Sony MHC-W77AV Operating Instructions Manual

Chapter 3:
the
stlelle,
Listening to the Radio
Presetting Radio Stations
Playing Preset Radio
Stations
1 2 Chapter 3: the Radio
—————— eae
Listening to the
Radio
When you want to play a radio program,
you can have the tuner automatically scan
the radio frequencies and tune in the
stations with clear signals. This feature
saves you time in searching for stations
with clear signals. However, stations with
weak signals may be skipped by automatic
tuning. Manually tune in the ones skipped
by automatic tuning.
SYSTEM
POWER > ON
1 Press TUNER/BAND repeatedly until
the band you want appears in the
display.
As you press this button, the band
changes as follows:
FM «+> AM
2 Press TUNING MODE repeatedly until
"AUTO" appears in the display.
3 Turn the JOG dial clockwise to scan for
higher frequency stations. To scan for
lower frequency stations, turn the JOG
dial counterclockwise.
The tuner starts scanning radio
frequencies, and stops automatically
when it finds a clear station.
"TUNED" appears in the display.
"STEREO" also appears if the tuned FM
station is broadcasting in stereo.
4 If vou do not want to listen to the station
selected, turn the JOG dial again to
restart the scan.
When the desired station is not
tuned in
Automatic tuning may skip stations with
weak signals. Tune in the station manually.
1 Press TUNING MODE repeatedly until
"MANUAL" appears in the display.
2 Keep turning the JOG dial until the
desired station is tuned in.
To improve AM broadcast reception
Reorient the supplied AM loop antenna.
&
AM
\
To change the AM tuning interval
The AM tuning interval is preset to 10 kHz
in the factory. If you need to change the
interval, do as follows:
1 Turn on the power.
2 Change the band to AM.
3 Turn off the power.
4 Turn the power back on while pressing
ENTER/NEXT.
After changing the AM tuning interval,
reset the preset radio stations. To reset the
interval to the factory setting, follow the
same procedure.
When an FM program is not received clearly
Press STEREO/MONDO on the remote so
that "MONO" appears in the display. There
will be no stereo effect, but the reception
will improve. Press STEREO/MONO again
to restore the stereo effect.
One Touch Play feature
Press TUNER/BAND when the power is
off. You will be able to start listening to the
last received station without pressing any
other buttons.
Automatic Source Selection
If you press TUNER/BAND while you are
listening to other sound source, the tuner is
selected and the last received station plays
automatically.