Listening To The Radio - Sony R-D-S EON MHC-2900 Operating Instructions Manual

Chapter 3:
the
stlelle.
Listening to the Radio
Presetting Radio Stations
Playing Preset Radio Stations
RDS Receiving
Chapter 3 : the Radio
aaa eee eee
Listening to the
Radio
When you want to play a radio
programme, you can have the tuner
automatically scan the radio frequencies
and tune in the stations with clear signals.
This feature saves you time in searching for
stations with clear signals. However,
stations with weak signals may be skipped
by automatic tuning. Manually tune in the
ones skipped by automatic tuning.
1 Press TUNER/BAND repeatedly until
the band you want appears in the
display.
As you press TUNER/BAND, the band
changes as follows:
FM — MW — LW
(en |
63 160 400 TK 28k Boe tek (HH)
2 Press TUNING MODE so that "AUTO"
and "TUNING" appear in the display.
3 Press TUNER/TIMER (+/-).
The tuner starts scanning radio
frequencies automatically, and stops
when it finds a clear station. "TUNED"
appears in the display .
"STEREO" also appears if the FM
station tuned is broadcast in stereo.
~*> Av. :
aq TUNED STEREO pe
o~ry~<™
SS 0 WO tk 25k Gm Tek Oe
4 i you don't want to listen to the station
selected, press TUNER/TIMER (+/-) to
restart the scan.
When the desired station is not
tuned in
Automatic tuning may skip the station with
weak signal. Tune in the station manually.
1 Press TUNING MODE so that only
TUNING is lit.
2 Press TUNER/TIMER (+/-) repeatedly
until the desired station is tuned in.
To improve AM broadcast reception
Reorient the supplied AM loop aerial for
AM (MW and LW.)
MW/LW
When an FM programme is not clear to
receive
Press STEREO/MONO so that "MONO"
appears in the display. There will be no
stereo effect, but the reception will
improve. Press STEREO/MONO again to
restore the'stereo effect.
One Touch Play feature
Press TUNER/BAND when the power is
off.
You will be able to start listening to the last
received station without pressing any other
buttons.
Changing the FM
Reception Mode (for the
C.1.S. model)
When you want to receive an FM broadcast
in PILOT TONE mode, change the setting
as follows:
1 Select FM band (65~74 MHz) with the
TUNER/BAND button.
2 Press POWER to turn off the power.
3 While pressing the TUNER/TIMER (-),
press POWER to turn it on.
To reset to POLAR mode
Repeat this same procedure.
Important
Stored stations will be erased from the
memory when you change the FM
reception mode.