Table of Contents
Advertisement
VCR Plus+ Setup (continued)
*Important: If the remote contro! POWER, ACTION, PROG, CHAVY, INDEX/ M/A SKIP or ADD/DLT button
does not work when pressed, press the VCR button on the remote and try the button again.
Manual VCR Plus+ Channel Setup
Complete this page only if Type B
connection method (pg. 12) is used.
* Before you begin, complete the Channel Setup
Preparations below left.
Important Note:
If your VCR connection type changes from type A to B,
perform "To Setup the VCR in Case a Cable Box or DSS
Receiver was Installed or Replaced" section on page 17
before proceeding with these steps.
wN
1 Follow steps 1 ~ 3 on page 38.
--
VCR
Plus+ CH SET UP --
DELETE
press AV to select
Pere
"MANUAL SET," and then
press P to SET.
SELECT: 4 Y KEY
SET
7» KEY
END
: ACTION
KEY
IMPORTANT NOTE:
For step "3," use the list you prepared. You may leave
lines blank if you don't receive that station, or if the
zt
GUIDE CH number and the CABLE (or TV) CH numbers
Channel Setup Preparations
are the same.
NOTE: Complete the steps on this page if your
VCR Plus+ CH SET UP
cable box can be controlled with the VCR, or
GUIDE CH
CABLE C
your VCR hook-up resembles "B" on page 12.
3 Press D to move the shaded
> m
E
: is
Prepare a list like the example below.
area to the right side.
02
--
This list will help you smoothly enter the information
SELECT:A Y KEY
needed in step "3" at right.
SET
:b KEY
END
¡ACTION
KEY
Then, press AY to change
CABLE or TV CH number.
You will need the following to complete the list:
@ A line up of normal and/or cable stations you
receive along with the channel numbers your TV
receives them on. Á cable channel line-up chart
is supplied by your cable company.
Next, press dl to set the number.
Now, press AY to continue.
VCR Ptus« CH SET UP
GUIDE
CH
CABLE
CH
ll A list of Guide (VCR Plus+) channel numbers
pi
m
assigned to the stations you receive. This list is
Repeat this operation until the list
available in TV Guide and the TV listings found
is complete.
il
in selected newspapers.
END
ACTION KEY
1 Make a chart with 3 columns like the example
below. In the left column, fill in the name or call
Press AV and P to select the incorrect CABLE or TV CH
letters of the stations you receive.
number. Then, press AV to change, or ADD/DLT to delete
2 Inthe middle column, fill in each station's
the channel
aragna Guide (VCR Plus+) number found in
:
uide, newspapers, etc.
3 In the right column, fill in the channel number
;
that your TV receives the station on from your
4 Press ACTION three times to exit
channel line-up.
the VCR Plus+ CH SET UP mode.
EXAMPLE ONLY
Broadcast or | Assigned
Guide
Cable
(VCR Plus+)
Station Name [ channel no.
ER
| CBS |
MOX |
TOC
LI
40
To Enter More Programs
Channel
no. your TV
receives the
station on
leave thís mode.
* Once local channels have been programmed, they will
CTN,
* Make each entry within 5 minutes or the VCR will
stay in memory, even in the case of a power failure.
VCR Plus+GOLD, C?, ALL SET and PlusCode are trademarks
of Gemstar Development Corporation.
The VCR Plus+ GOLD system is manufactured under license
from Gemstar Development Corporation.
Advertisement
Table of Contents
