Sharp Viewcam Z VL-Z7U Operation Manual page 77

To Record from an External
Source
1
2
3
In Tape Playback mode, press the
DISPLAY button until the mode
screen appears.
Select "MENU", then "EXECUTE" by
using the Operation button (see page
32).
Press ,/ or A to select _f 2, then
press the center of the Operation
button.
4 Press ,/ or A to select"S-VIDEO
IN", then press the center of the
Operation button.
Notes:
,, To pause recording, press /... Press /.. again
to resume recording.
• To operate by remote control, perform steps 1
to 7 above, and press the TAPE REC START/
STOP button, then press the PAUSE/STILL
button ( II ).
,, If "NO SIGNAL" is displayed on the
camcorder screen, check that the audio/
videdS-video cable is properly connected.
Press ,/ or L ', to select "ON" (for S-
video connection) or "OFF" (for video
connection), then press the center of
the Operation button.
Press the DISPLAY button to turn off
the menu screen.
o "S-VIDEO" appears on the screen
during a pause or Recording
Standby mode when you set the S-
VIDEO IN menu item to "ON" in step
5 above.
7 Begin playback on the source
equipment connected to the
camcorder.
o Check the camcorder screen to see if
the picture is properly received.
8 Press the Start/Stop button on the
camcorder, then press .*,_ to begin
recording.
==.
63