Sharp Viewcam Z VL-Z7U Operation Manual page 118

Appendix
Remote control does REMOTE menu item is set to "OFF". Set REMOTE menu item to "ON"
not function /P
Remote control battery has run Replace remote control battery with
!iii!_iiiiii!
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii:i:i _
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiii_
_i_ilililililililililililililililiiii
"EO07" is displayed
on the screen, and
unable to operate
normally.
down
Remote control used beyond opep
ating range
Intense daylight falling on
camcorder remote sensor
Obstacle between remote control
and camcorder remote set,sot
The camcorder may be damaged
new one (p. 13)
Use remote control within operating
range (p. 47)
Protect remote sel/sor from expo
sure to intense daylight (p. 47)
Remove obstacle or use remote
control from different angle (p. 47)
Do not take out a cassette, and call
for service (p. 105)
Notes:
'* This unit is equipped with a microprocessor. Its performance could be adversely affected by
external electrical noise or interference. If this should happen, turn off the power and disconnect
the unit from any power sources, including the lithium battery, etc. Then reconnect the power
sources to resume operation.
,* If the characters displayed in the viewflnder or on the LCD monitor screen appear to malfunc-
tion, disconnect the power source and remove the lithium battery, then reconnect the power
source, insert the lithium battery, and turn the power on again. The characters on the monitor
should be normal. Set the date and time, then resume operation.
104