Sharp Viewcam Z VL-Z7U Operation Manual page 105

Adjusting the Backlight
1 Press the DISPLAY button until tile
mode screen appears.
2
3
Press ,7 or ?, on the Operation
button to select "MENU", then press
the center of the Operation button.
Press / or _.' to select"EXECUTE",
then press the center of the Operation
button.
4 Press v' or ..Ato select LCD,then
press the center of the Operation
button.
5 Press ,7 or z!_to select"BACK-
LIGHT", then press the center of the
Operation button.
Press v' or _.' to select"NORMAL' or
"BRIGHT", then press the center of
the Operation button.
Available modes:
All modes
A confirmation sound is made when you
turn on or off the Power switch, press the
Start/Stop button, or perform other
designated operations. Use the procedure
below to turn off the confirmation sounds.
• The example screens shown are for Tape
Camera mode.
1 Press the DISPLAY button until the
mode screen appears.
2
3
Press v' or ?, on the Operation
button to select "MENU", then press
the center of the Operation button.
Press 'q or ?,, to select"EXECUTE",
then press the center of the Operation
button.
4 Press / or ..A, t o select _1, then
press the center of the Operation
button.
5 Press / or .._,to select"BEEP", then
press the center of the Operation
button.
NORMAL: For use indoors or _1 ,_,., "_J-._,,
moderate lighting conditions. I
BRIGHT: For use outdoors under I
strong lighting conditions, such I _!1 ''_
as bright daylight. J
Press the DISPLAY button to turn off
the menu screen.
6 Press / or ,:..'to select"OPP", then
press the center of the Operation
button.
7 Press the DISPLAY button to turn off
the menu screen.
Note:
,* if you select "OFF", the focus confirmation
sound in Card Camera mode will turn off.
iiiiiiiiiiiiiiiiiii!!!!J!!iiii
=_
91