Table of Contents
Advertisement
Available languages
Available languages
,
.
.
Insure that the copper ground strap IS CONNECTED
between the middle post of the main terminal
connection block and the range chassis.
The middle wire of the service cord MUST connect to
the neutral (middle) post of the main terminal block.
The other two wires of the service cord connect to the
outside posts of the main terminal connection block.
Polarity is unimportant.
Position strain relief with flanges on top of conduit plate
as shown and secure to service cord.
,
.
.
The range conduit must be routed and properly
connected to an approved electrical junction box
behind the range.
The red and black wires from the range conduit must
respectively connect to the red and black service wires.
An approved wire connector must be used.
Both the white wire and the uninsulated (bare) wire
from the conduit should connect to the white service
wire as shown. The bare wire is the range chassis
ground.
RED--_
WHIT(--_
B LACK ---3k_
GROUND
STRAP
_
_'_L
(CONNECTE0
AT
FACTORY)
STRAI
N-----"
REL I EF
MA_ IN
T£RMINAL
CONNECTION
BLOCK
MIDDLE
WIRE
OF
SERVICE
COR0
I
CONDUIT
PLATE
1
CONDUIT
PLATE
I
J
I
I
REMOVE
KNOCKOU
'i_
SERVICE
CORD
(PIGTAIL)
USE.
L OUTLET
MOUNTED
FLUSH
IO WALL
ALTERNATE INSTALLAT ION
OUTLET
TO BE
ROTATED
AS
SHOWN
IF
NOT
FLUSH
TO WALL
FIGURE 8
NORMAL - 3 WIRE PLUG
NOTE: ROUTE
RANGE
CONDUIT
SO
THAT
IT
CONTAINS
NO
KINKS
AND
DOES
NOT
INTERFERE WITH INSTALLATION OF UNIT.
/I
(RE)}
NEUTRAL
{BLACK)
CIRCUIT
{POWER SUI_Y)
RANGE GROUM:IEDTHROUGHNEUTRAL CONDUCTOR.
FIGURE 9
NORMAL - 3 WIRE CONDUIT
Advertisement
Table of Contents
