Delete Characters On Output Result - Inateck BCST-91 Instruction Manual

Enter Setup
prefix and suffix. Please refer to the Appendix for the supported prefix/suffix characters.
Steps to set the prefix as "#" and the suffix as "D" are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set Prefix" barcode.
3. Read the "#" barcode in Appendix I.
4. Read the "Set Suffix" barcode.
5. Read the "D" barcode in Appendix I.
6. Read the "Exit and Save" barcode.
Note: After you successfully set prefix and suffix, the BCST-91 will by default output scanning
result with prefix and suffix.
Set prefix (*)Show prefix
(*)Show suffix Set suffix
Hide prefix Hide suffix

Delete Characters on Output Result

When outputting scanning result, the BCST-91 supports deleting 0 – 99 digit(s) front
characters and 0–99 digit(s) end characters from a barcode.
Steps to set deleting front 12-digit characters and end 4-digit characters are as below:
1. Read the "Enter Setup" barcode.
2. Read the "Set the Number of Front Digit(s) to be Deleted" barcode.
3. Scan the "1 Digit" barcode.
4. Scan the "2 Digits" barcode.
Exit and Save
37