Delete Character(S) On Output Result; Inventory Mode - Inateck P6 User Manual

（*）Recover Prefix
（*）Recover Suffix

Delete Character(s) on Output Result

Inateck P6 can help users delete character(s) on output result, either beginning
characters or the ending ones. 0 to 99 digits can be deleted. As default setting, no
character, or say 0 digit is deleted as output result. More details are as below.
1. Scan "Enter Setup" Barcode
Enter Setup
2. Scan "Delete Beginning Character(s)" Barcode or "Delete Ending Character(s)"
Barcode
Delete Beginning Character(s)
3. Scan the digit(s)barcode to be deleted.
（*）0 digit
2 digits
4 digits
6 digits
EN EN
Hide Prefix
Hide Suffix
Delete Ending Character(s)
1 digit
3 digits
5 digits
7
7 digits
8 digits
4.Scan "Exit with Save" Barcode to end the setting
Note: Refer to the setting of "delete 0 digit character" if no character should be
deleted.

Inventory Mode

Users may use inventory mode to keep scanned barcodes in the buffer of Inateck
P6, and upload them to computer in batches. Under inventory mode users are not
restricted to the time and location when upload data. Of course, history data can be
cleared in buffer. More details about inventory mode are as below.
1. Scan the barcode to enter Inventory Mode
Enter Inventory Mode
2. Scan the barcode to return to Common Mode
（*）Return to Common Mode
3. Scan the barcode to clear data in buffer (for Inventory Mode only).
Clear Data in Buffer(for Inventory Mode only)
4. Scan the barcode to upload data from buffer (for Inventory Mode only)
Data Upload (for Inventory Mode only)
8
9 digits
Exit with Save