Table of Contents
Advertisement
Enter Setup
Inventory Function
When under inventory mode, barcodes will be saved in the buffer of the barcode scanner
and can be uploaded for many times as per your need. You can also erase the barcodes in
the buffer after uploading them to your device.
Note: You do not need to scan "Enter Setup" or "Exit with Save" when reading the barcodes
below. The functions can be achieved simply by scanning the corresponding function setting
barcodes.
Enter Inventory Mode
(*) Return to Common Mode
If you want to erase the data in buffer, scan the "Erase Buffer" barcode
(for inventory mode only)
Erase Buffer (for inventory mode only)
Scan the "Upload Data" barcode to upload the data in buffer storage
(for inventory mode only)
Upload Data (for inventory mode only)
Scan the "Upload Number Collected"barcode to upload the number of barcodes collected
(for inventory mode only)
Upload Number Collected (for inventory mode only)
When under inventory mode, if you do not want to scan the same barcode twice, you may
set the scanner as "Enable Duplicate Scan Check". After the setting, the scanner will let out a
Exit and Save
12
Advertisement
Table of Contents
