Service Programmes - Siemens EQ500 classic TP51 Series Information For Use

Do not clean in the dishwasher.
▶
→ Fig. -
23 31
Note: The door can only be closed if
the brewing unit and drip tray are in-
serted correctly.
12.8 Service programmes
After certain time intervals, your appli-
ance will recommend that you use
the service programmes. Use the ser-
vice programmes to clean your appli-
ance thoroughly.
ATTENTION!
Improper cleaning and descaling or a
delay in doing so may damage the
appliance.
Immediately perform the descaling
▶
process in accordance with the in-
structions.
Only put cleaning tablets in the
▶
ground coffee compartment.
Do not put descaling tablets or
▶
other products in the ground cof-
fee compartment.
Notes
The display indicates the progress
¡
of the descaling or cleaning pro-
cess.
If your appliance is not descaled in
¡
good time, the display will show
the following message: "Descaling
overdue. Appliance is locked.
Please press menu for 3 sec.".
If your appliance has been locked,
¡
you can only operate it again once
the descaling process has been
carried out.
If you accidentally interrupt the ser-
¡
vice programme, you must reset it.
→ "Resetting service programmes",
Page 59
Tips
If you use a water filter, this will
¡
prolong the time until you have to
run a service programme.
Cleaning and servicing en
You can combine "Descale" and
¡
"Clean" using the "calc'nClean"
service programme.
Clean your appliance with a soft,
¡
damp cloth immediately after a
service programme to remove any
descaling solution residues and
prevent corrosion.
Using the service programmes
Notes
If you are using the service pro-
¡
gramme "Cleaning and care",
clean the brewing unit beforehand.
→ "Cleaning the brewing unit",
Page 58
If you are using the service pro-
¡
grammes "Descale" or
"calc'nClean", first clean the brew-
ing unit and prepare the descaling
solution.
Press ⁠ .
1.
Use and
2.
and care" and press
Use and
3.
quired programme and press
e.g. "Descale".
The display will guide you through
a
the programme.
Preparing descaling solution
Fill a container with 0.5 l lukewarm
1.
water.
Add a descaling tablet to the water
2.
and stir until it is fully dissolved.
Resetting service programmes
Perform the following steps if a ser-
vice programme is interrupted, e.g.
due to a power failure.
Empty the container and put the
1.
end of the suction pipe in the con-
tainer.
Rinse out the water tank.
2.
Fill the water tank with fresh, non-
3.
carbonated water up to the "max"
marking.
to select "Cleaning
⁠ .
to select the re-
,
59