Table of Contents
Advertisement
DEE 1521, DEE 2127
If the power supply cable has to be laid behind the
rear wall of the device, sufficient space must be left
between the device and the wall. A maximum of
16 mm can be compensated by adjusting the upper
mounting device.
Use the lower spacers to align the rear of the device
parallel to the wall.
For additional safety, the spacers can be screwed to
the wall.
www.dimplex.de
Finally, tighten the upper fastening device.
4.7
Mounting the hydraulic block
Fit the cold water flexi hose (A) and hot water pipe (B)
into the sealing diaphragm.
Swivel the hydraulic block upwards (C).
6721873500 (2023/07)
C
B
English
A
EN-13
Advertisement
Table of Contents
