Water Heater Mounting - Electrolux EWH 30-100 Fmx EEC User Manual

8
www.home-comfort.com
be maintained by the water heater every
time it is turned on.
Press SET and hold for 3 seconds. The
set temperature will flash (35 °C). If you
agree, quickly press SET once to confirm.
The temperature is set in the instrument's
memory and heating will start. If you want
to change the temperature, use "+" or "-"
keys. After selecting the temperature, it
will flash for 3 seconds, then you need to
quickly press SET once to confirm. If you do
not press SET to confirm, the temperature
you have selected will flash for 3 seconds,
after which heating will begin, the selected
temperature will only be maintained until the
water heater is turned off by the user. The
selected temperature will not be saved.
The temperature indication on the display
shows the temperature of the water in the
water heater. To see what temperature is set
during heating, press SET once quickly and
the set temperature will be displayed for 3
seconds. After 3 seconds, the temperature
of the water in the water heater will be
displayed.
When the temperature reaches the set
temperature, the "HEATING" indicator will
turn off.
Antifreeze mode
To prevent water from freezing, the water
heater automatically starts heating when the
water temperature in the inner tank drops
below 6 °C. When the temperature reaches
10 °C, the heating stops. The function works
when the device is connected to the power
supply. It is available in FmxDL EEC series.
If there is a power outage in the room
1. If the electricity is cut off during heating,
then after turning on the electricity in the
room, the water heater will turn on for
heating, as it was set before.
2. If the water heater was not turned on,
was in the "STAND BY" mode, after
turning on the electricity in the room, the
water heater will not start heating.

Water heater mounting

Make sure to use original parts supplied by
the manufacturer to mount the water
heater, which can hold the weight of the
water filled heater. Do not mount the water
heater on the holding until you are sure
that it is secure. Otherwise, the water
heater may fall off the wall, causing
damage or serious injury. When choosing
sites for holes for fastening bolts, make
sure that there is at least a 0.2 m gap on
both sides from the walls of the bathroom
or other room to the water heater body,
and at least 0.5 m at the side of the pipe
connection, to provide access for
maintenance if necessary.
If the water heater is supplied with water
directly from wells or water towers, during
operation a coarse filter has to be used for
cold water coming into the water heater.
1. Installation of water heaters of Fmx EEC,
FmxDL EEC series is greatly facilitated
by the ability to install them both
vertically and horizontally anywhere
in your house, in a heated (!) room. It
is advisable to install the water heater
as close as possible to the point of use
of hot water, because the shorter the
length of the pipes, the less heat loss is.
As shown in Fig. 9, when installing the
water heater horizontally, the supply
pipes must be located on the left. When
installing the water heater next to a wall,
leave the recommended clearance for
maintenance. Do not install the water
heater on a horizontal surface and close
to the floor.
2. After selecting the mounting location,
determine the locations for the two hook
bolts (depending on the specifications of
the selected item). Make two holes in the
wall of the required depth using a drill
bit that matches the size of the mounting
bolts, insert the screws, turn the hook
up, tighten the nuts, and then install the
electric water heater on it (see Fig. 5).
Mounting anchor
Figure 5
Storage
27
volume, l
Distance be-
tween holes,
mm
46 73 93
196