Care And Cleaning - Creda REFLECTION Installation And Use Instructions Manual

CARE AND CLEANING

3. CONTROL PANEL / TRIMS / INNER DOOR PANEL & GLASS
TRIMS
4. REPLACEMENT OF THE OVEN LAMP
MAIN OVEN LAMP
5. HOW TO CLEAN THE LAMP LENS
MAIN OVEN LAMP
(a) Control Panel
OVEN
Regularly wipe with a clean, damp cloth and polish with a
DOOR
clean, dry cloth.
(b) Trims
It is advisable to clean the trims regularly to prevent any
build up of soiling which may detract from the
appearance of the cooker. The recommended method of
cleaning is to wipe over the trims with a clean, soft cloth
wrung out in hot water, or mild non abrasive cleaner. (If in
doubt try the cleaner on a small area of trim which is not
noticeable in normal use), then after wiping with a cloth
wrung out in clear water, dry with a clean, soft cloth.
(c) Inner Door Panels & Glass
Open the door fully. The glass panel may now be washed.
Stubborn stains can be removed by using a well soaped,
fine steel wool soap pad.
DO NOT use scouring pads, or abrasive powder, which
will scratch the glass.
Warning: Before removing lamp lens, please ensure that
the electricity supply to the appliance is switched off
and the appliance is fully cold.
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove the lens.
Carefully unscrew the bulb anti-clockwise. Fit
replacement bulb (15W 300˚C SES). Fit replacement
bulb and refit lens.
Warning: Before cleaning lamp lens, please ensure that
the electricity supply to the appliance is switched off
and the appliance is fully cold.
Open the oven door and remove the oven shelves.
Using a thick cloth, grip the lamp lens, unscrew anti-
clockwise and remove. Clean with a non-abrasive
cleansing cream and refit lamp lens.
DO NOT use scouring pads, or abrasive powder, which
will scratch the glass lens
27