Using An Rf Transmitter; Using The Usb Connector - MACDEV CYBORG 6 Owner's Manual

Dwell - the amount of time your solenoid is given power - the Cyborg 6 should be set to a maximum of 10ms. If the
weather is very cold, or your marker requires it, you may set this a little higher.
Debounce - the amount of bounce filtering applied by the software. This setting may be increased to remove un-
wanted trigger bounce.
Eye delay - this is a parameter used to give a paintball time to settle in the breach of the gun. If you have unex-
plained ball breakage, then you may need to increase this setting.
Eye sensitivity - the sensitivity of the software to changes in your eyes. Please do not change this parameter unless
directed (default 10).
Bolt delay - a time used in the software for effective tracking of the paintball bolt. Please do not change this pa-
rameter unless directed (default 8ms).
Clearing shot - a clearing shot function will allow the user to force a shot by holding the trigger in - even if the eyes
cannot detect a ball. Set this to off, if you would not like to use this function.
FSDO time - FSDO stands for First Shot Drop Off. If you leave your gun for some time, and the first shot is lower
than it should be, then you can use this parameter to correct it. This parremter is the time that the software waits
before correcting for FSDO.
FSDO dwell - this is the amount of extra dwell given to the solenoid to overcome FSDO - if directed to do so by the
above parameter.
Preferences category
This category contains settings related to the user experience.
Boot screen - The boot screen can be disabled if desired.
Cyborg 6.indd 15-16
Sound - sound can be disabled if desired.
ROF meter - the settings for the ROF meter may be changed here. You can adjust the number of shots sampled,
and if the maximum is held to the peak (peak hold).
System category
This category contains system information and settings.
Total shots - total shots since your board was made.
Version - current software version.
Zero pressure - This is used to zero your pressure transducer. If your pressure transducer is reading incorrect val-
ues it can be zeroed here. You must have your gun empty of all pressure before performing this action - if it is not,
you will get incorrect transducer readings.

Using an RF transmitter

Your stock board has provision for an RF transmitter attachment. To use the RF transmitter function, you must
plug a compatible RF transmitter module into the RF transmitter plug (directly under the eye plugs on your
board), and it will be activated automatically.

Using the USB connector

Your stock board has a mini USB connector on the bottom of the board to the right of the 9V battery. The USB
connectivity may be used to update your software via a standard USB/mini USB cable.
Never update your board with software unless it has been downloaded directly from the MacDev website
(www.macdev.net), the use of non genuine software on your stock board will immediately void your en-
tire marker warranty.
14
8/04/2014 1:06:01 PM