Specifications - MACDEV CYBORG 6 Owner's Manual

Symptom Possible Cause
Your Cyborg is Beam sensor is turned off
chopping paintballs
Beam sensor is dirty or blocked
Loader is set on a force setting too
high for your paintballs
Detents are missing or incorrectly
installed
Eye delay too low
Your Cyborg will not fire The trigger is set up incorrectly
The beam sensor is on, and there are
no paintballs loaded
The solenoid is not plugged in
Your Cyborg fires high on Creeping regulator
the first shot or
inconsistently.
Your Cyborg fires low on Sticking drivetrain or bolt
the first shot
Cyborg 6.indd 23-24
Solution
Always play with the beam sensor
enabled.
Clean the breach, bolt and sensor.
Some force fed loaders can apply enough
force to break a fragile paintball. If this is the
case, consult your loader manual to reduce
the force setting.
Replace or re-install your detents.
Increase the eye delay (pg 13)
Ensure that the trigger actuates the micro-
switch by adjusting the actuator screw.
Load some paintballs.
Plug the solenoid into the board.
Clean and lubricate both regulators, ensure
that the seat and piston are in good condi-
tion.
Clean and relubricate the drivetrain and bolt.
If you continue to have problems:
-increase the dwell by 1-2 ms.
-increase the ABS parameter on your board.
CYBORG 6 SPECIFICATIONS
Physical
Length 221mm (512mm with barrel)
Width 32mm
Height 215mm
Weight 935g with barrel and battery
Barrel Threads Autococker
Performance
Operating pressure 200psi
Maximum Rate of Fire 30 BPS
Electronics
Software C6 Militiasoft V1.05
Hardware C6, V1.01 (Lead Free)
Display Full colour OLED, low power usage 128x32px
Power 9V standard battery 6LR61
Fire modes Semi, NXL, PSP, Response, Burst, Full Auto
Connectivity Mini USB
Solenoid 5V 1W
MACDEV TECHNICAL
ASSISTANCE
If you require technical assistance,
please contact your local MacDev
service centre. You can also find
assistance on the MacDev support
website :
22
www.macdev.net/guides.
8/04/2014 1:06:02 PM