Quick Setup; Switching Your Cyborg On And Off; Firing Your Marker; Understanding The Beam Sensor - MACDEV CYBORG 6 Owner's Manual

QUICK SETUP

Switching your Cyborg on and off

The on/off button is located on a membrane pad on the rear of the frame. Push the
button with the power symbol ( ), when done correctly, your OLED will display the
MacDev logo and the marker will be set with the beam sensor system on and ready
to fire. Turn your marker off by holding the power button down until the OLED system
goes blank.

Firing your marker

If a paintball is loaded in your marker, and the power is switched on, you may fire the
marker by pulling the trigger. If a paintball is not loaded, then you need to either load
one, or read the section below on disabling the beam sensor.

Understanding the beam sensor

Your marker is equipped with a visible light sensor to determine if a paintball is cor-
rectly loaded. This system is used to prevent accidental ball breakage due to misloaded
paintballs. The OLED indicator on the side of your grip will show you the status of the
beam sensor:
Ball loaded Sensor disabled
No ball loaded Sensor fault

Disabling the beam sensor

To disable the sensor (for dry firing), hold the scroll button on the membrane pad (
until the beam sensor disabled icon appears on the OLED display. You can re-enable the
beam sensor the same way.
Cyborg 6.indd 9-10
Membrane Pad

Installing a preset air system

Your marker comes equipped with a high quality venting ASA (Air System Adaptor)
that is designed for use with commercially available air/nitrogen systems.
The venting ASA included with your marker uses a knob to turn the air from your
preset system on or off. Before installing your preset air system, you must unscrew
the ASA knob by approximately 3 turns.
Once this is done, carefully screw your air system into the ASA until it stops.
WHEN SCREWING YOUR AIR SYSTEM INTO THE ASA, THE THREADS SHOULD BE
LOOSE. IF AT ANY POINT THEY BECOME TIGHT, DO NOT FORCE THE THREADS,
THIS MAY CAUSE DAMAGE TO YOUR AIR SYSTEM OR YOUR MARKER!
Power button
(for power on/off)

Turning the air on and off

Scroll button
To pressurise your marker, screw the ASA knob down until it stops. This will depress
(for eyes on/off and
the pin on the end of your air system and pressurise the marker (provided you have
programming)
sufficient air in your air system).
OLED Display
To depressurise your marker, unscrew the ASA knob until you hear the air being
Battery meter vented from the cap. Your air system is now turned off and safe to remove.
Cycle mode
NOTE: WHEN YOU UNSCREW THE ASA KNOB, YOUR MARKER MAY STORE ONE
)
Cycle speed (max)
SHOT. POINT THE MARKER IN A SAFE DIRECTION AND FIRE OFF THAT SHOT
BEFORE ENTERING A SAFE AREA.
Sensor status
Pressure meter/
ROF meter
Installing an air system
Turning the air on
8
8/04/2014 1:05:57 PM