FlowLine EchoBeam LR80 Series Manual page 52

Advanced Configuration
SETTINGS
Settings have 4 categories (Range Adjust, HART, Level Variables and Signal Properties).
| 52
RANGE ADJUST
These settings are used to fine tune EchoBeam
Maximum Range (d)
•
o This setting defines the maximum distance that the sensor will detect
valid echo returns.
o Value will be in the Units defined in Step 1.
o EchoBeam will not read a level beyond this setting.
®
o Default setting will be 105% greater than the Sensor Height value.
If Sensor Height is set to 20 feet, then Maximum Range default will

be equal to 21.0 feet.
Maximum Range
Write to Unit is used to save any changes to the sensor. Any changes
made are not saved into EchoBeam
.
®
until Write to Unit is pressed.
®
Section Eight
MN310255 Rev 10