Playing Back On Your Tv; Audio Dubbing - Panasonic NV-DS29B Operating Instructions Manual

ps es
[VIDEO IN
: & ——— 21-pin Adaptor
'S-VIDEO IN]
Playing Back on Your TV
By connecting your Movie Camera with your TV, the recorded
scenes can be viewed on your TV screen.
Before connecting them, tum off the power of both the Movie
Camera and TV. :
1 Connect the [A/V OUT] Socket of the Movie Camera
and the Video and Audio Input Sockets of the TV.
Using the AV Cable 0. make a connection with the TV. If the
TV has an S-Video Socket, connect the S-Video Cable (2) (not
supplied), too.
To Make the indications Appear on the TV Screen
Press the [OSD] Button @ on the Remote. Controller.
®\f your TV is not equipped with AV Input Sockets, the 21-pin
Adaptor (purchase separately) is necessary. Consult your dealer.
dS FR dd Pd ed ad Pd Pd Od Od
Audio Dubbing
You can add music or narration to the recorded Cassette.
elf the tape recorded in the [16bit] Mode is dubbed with the Audio
Dubbing function, the original sound is erased. (If you wish to
preserve the original sound, use the [12bit] Mode when recording.)
Audio Dubbing cannot be performed on a recording done in LP
Mode. (> 21)
1 Switch the Movie Camera over to the Still Playback
Mode where you want to add new sound.
2 Press the [A.DUB] Button on the Remote Controller.
The same setting can be done using [RECORDING SETUP]
Sub-Menu on the [VCR FUNCTIONS] Main-Menu.
3 To start Audio Dubbing, press the {f1] Button.
To Cancel Audio Dubbing
Press the [I] Button.
The Movie Camera is in the Still Playback Mode again.
To Play Back the Sound Recorded by 12bit Audio
Dubbing
Set [VCR FUNCTIONS] >> [PLAYBACK FUNCTIONS] >> [12bit
AUDIO] >> [ST2] or [MIX].
STt: It plays back only the original sound.
ST2: It plays back only the sound added by Audio Dubbing.
MIX: It plays back both the original sound and the sound added by
Audio Dubbing simultaneously.
For other notes concerning this item, see page 44.
37