Table of Contents
Advertisement
Setup
3. Setup
AC Power
The Cumulus HP has a fixed voltage power supply, and it can work with an input voltage range of either
120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
•
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
Orientation
The Cumulus HP must be mounted on a flat, level, and stable surface.
•
Before deciding on a location for the product, always make sure there is easy access to the product
for maintenance and programming.
•
Make sure that the structure can support the weight before positioning the product (see the
Technical
Specifications).
•
When mounting the product on the floor, make sure that the product and cables are away from
people and vehicles.
This product may NOT be tilted. This product should be level when on a surface.
While operating the Cumulus HP, make sure there is adequate fog fluid and water in the
machine to prevent pump and heater damage. When the fog fluid level or water level
becomes low, simply add more fog fluid or water to continue using the Cumulus HP.
Cumulus HP User Manual Rev. 1
Safety
Notes.
4
Advertisement
Table of Contents
