Table of Contents
Advertisement
Filling the Fog Fluid Tank
The Cumulus HP fog fluid tank must be filled with LLG (Low Lying Gallon) fluid from Chauvet DJ in order
for the product to function. To access and fill the fog fluid tank:
1. Open the fluid refill cover.
2. Open the fog fluid tank.
3. Fill with LLG fluid from Chauvet DJ.
4. Close the fog fluid tank, ensuring the fog fluid hose is inside.
5. Close the fluid refill cover.
While operating the Cumulus HP, make sure there is adequate LLG fluid in the machine to
prevent pump and heater damage. When the fog fluid level becomes low, simply add more
fog fluid to continue using the Cumulus HP.
Filling the Water Reservoir
The Cumulus HP water reservoir must be filled with distilled water in order for the product to function.
Water Inlet
The Cumulus HP has a water inlet connection (see the
water source via the included external hose.
•
The diameter of any external hose must be 4.8 in (123 mm).
•
The length of the external hose may be from 14–126 in (35–320 cm).
To install the external hose:
1. Insert the external hose to the inlet connection.
2. Release the hose and inlet to seal the connection.
To remove the external hose:
1. Push the retaining ring of the inlet connection in.
2. Pull the hose out.
When using the water inlet, the Cumulus HP will automatically pump the correct amount of water
into the reservoir whenever the water level is too low. This method is recommended to ensure the
reservoir never runs dry.
•
See
Automatic Water Pump
5
Product
Overview) that can connect to a distilled
to turn on the automatic pump function.
Cumulus HP User Manual Rev. 1
Setup
Advertisement
Table of Contents
