Setup; Ac Power; Fuse Replacement - Chauvet DJ HURRICANE 1000 User Manual

3. Setup

AC Power

The Hurricane 1000 has a fixed voltage power supply, and it can work with an input voltage range of either
120 VAC, 60 Hz or 220 VAC, 50 Hz, depending on the specific model.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
• Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.

Fuse Replacement

1. Disconnect the product from power.
2. Using a Phillips-head screwdriver, unscrew the fuse holder and pull it straight out.
3. Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
4. Re-insert the fuse holder and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Always replace a blown fuse with one of the same type and rating.
While operating the Hurricane 1000, make sure there is adequate fog fluid in the machine
to prevent pump and heater damage. When the fog fluid level becomes low, simply add
more fog fluid to continue using the Hurricane 1000.
5 Hurricane 1000 User Manual Rev. 3
Setup