Candy DOMINO Series Instructions For Use Manual page 9

FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 30 to 40mm thick.
The kit includes 4 tabs "A" and 4 selfthreading screws "B".
• Cut the unit.
• Stretch gasket "G" over the edge of the hole made, being careful to overlay the junction
edges (fig. 1.3b).
• Turn the cooktop over and put tabs "A" (fig. 1.3a) into the mountings, only tighten
screws "B" a few turns. Make sure that the tabs are mounted correctly as shown in the
figure 1.3c. Turn the tabs so that the cooktop can be put into the hole.
• Put the cooktop into the hole cut into the unit and position it correctly.
• Put tabs "A" into place, tooth "C" of the tabs should go into the hole.
• Tighten screws "B" until the cooktop is completely secured.
• Using a sharp tool cut off the part of gasket "G" which protrudes from the cooktop.
Take care not to damage the benchtop.
A
A
Fig. 1.3a
C
B
Fig. 1.3c
(figs. 1.3a, 1.3b, 1.3c)
A
A
A
A
A
A
D
G
A
Fig. 1.3b
G
9 9