Art ARTTRACK Installation Manual page 55

'OUT3':
Defines syncgroup #3. The default time delay related to syncgroup #1 is
960 .
For cascaded systems please connect 'OUT1' to 'ExtIn' of a slave controller
(see chapter 5.6 on page 66).
ART Synccard3 (master PCI card ONLY):
– 'ExtIn':
Please plug in the external source (TTL or video signal or master controller of
a cascaded system) for synchronization here. Please use the accessible port
without protective cap only. For configuration refer to chapter 5.5 on page 65. In
cascaded systems please connect the external source to the master controller
only.
'USB port':
Please plug in all USB based peripheral devices here (e.g.
communication with Flystick2/2+/3
less transceivers and Yost Labs wired inertial sensors (refer to
Guide
Hardware
ART Controller
accessing the
User's Guide
Connecting to the controller
'LAN network port':
Please connect the ART Controller
cable.
'Cascaded network port':
For cascaded systems please connect a slave controller to the
ter). Please refer to chapter 5.6 on page 66 for more detailed information.
'Power inlet':
Please connect to mains, refer to chapter A.2 on page 130 for detailed information
regarding technical specifications.
The power inlet is fuse-protected (2x4A, anti-surge type T) and features
a line filter for EMV protection.
In order to replace mains fuses (e.g.
the power cord first. Risk of electric shock !
There are two mains fuses since two power supplies are installed. So
the device is possibly still live although only one fuse has blown.
(refer to chapter 4.4.2 on page 34), Trivisio wire-
Inertial Sensors) You can also plug-in a USB pen drive for
DTRACK3
without the
to your local network using a twisted pair Cat 5
5.2 Installation of the Controller
RadioTransceiver2/3
DTRACK3 User's
frontend (refer to
).
ART Controller
ART Controller ) always unplug
for
DTRACK3
(mas-
55