Art ARTTRACK Installation Manual page 115

position 4 to 7: three syncgroups
position 8 to 9: unused
Connecting the finger thimble set with the hand target Just plug in the connector of
the finger thimble sets into the hand target as shown in figure 5.50 on page 114. Then
apply the finger thimbles to your thumb and fingers observing the order of the flexible
wires shown in figure 5.48a+b on page 112.
(a) The finger thimble connector in detail (b) Order of flexible wires (5-finger AR
Figure 5.50: Connecting the finger thimble set to the hand unit
Inserting the battery The
ies. Two batteries and a charger are provided with each
the battery in with the contact side first and then gently press the battery into the com-
partment until it snaps in (see figure 5.51 on page 114).
(a) Step1
Figure 5.51: Inserting the battery
thimble set)
Fingertracking hardware uses standard CAN NB-4L batter-
(Fingertracking
5.9 Discontinued hardware
(Fingertracking
Fingertracking set. Squeeze
(b) Step2
discontinued)
)
115