Table of Contents
Advertisement
Help Guide
Interchangeable Lens Digital Camera
ILCE-9M3
α9III
Select Finder/Monitor
Sets the method for switching the display between the viewfinder and the monitor.
MENU →
(Setup) → [Finder/Monitor] → [Select Finder/Monitor] → desired setting.
1
Menu item details
Auto: 1:
When you look into the viewfinder, the display is switched to the viewfinder automatically.
The eye sensor is deactivated and the display does not switch to the viewfinder depending on whether the monitor is
open or closed and the angle of the monitor.
Auto: 2:
When you look into the viewfinder, the display is switched to the viewfinder automatically.
The eye sensor is always activated and the display switches to the viewfinder regardless of whether the monitor is open
or closed and the angle of the monitor.
VF(Manual):
The monitor is turned off and the image is displayed only in the viewfinder.
Monitor(Manual):
The viewfinder is turned off and the image is always displayed on the monitor.
Hint
You can assign the [Select Finder/Monitor] function to your preferred key.
[
Custom Key/Dial Set.], [
key.
If you want to retain the viewfinder display or the monitor display, set [Select Finder/Monitor] to [VF(Manual)] or [Monitor(Manual)]
beforehand.
You can keep the monitor off when you take your eyes off the viewfinder during recording by setting the monitor display to
[Monitor Off] using the DISP button. Select [DISP (Screen Disp) Set] → [Monitor] and add a check mark to [Monitor Off]
beforehand.
When [Enlarge Menu Scrn] under [Enlarge Screen] is set to anything other than [Off], a message is displayed confirming whether
to set [Select Finder/Monitor] to [Monitor(Manual)]. When using the [Enlarge Screen] function, it is recommended that you set
[Select Finder/Monitor] to [Monitor(Manual)]. This will prevent the eye sensor from activating and switching to the viewfinder
display when you bring your face close to the monitor.
Note
Under strong light sources such as sunlight, the eye sensor may not detect your eye approaching and the display may not switch
to the viewfinder even when [Select Finder/Monitor] is set to [Auto: 1] or [Auto: 2]. In such cases, keep the eye sensor from being
exposed to the light source.
When [Auto: 2] is selected, the eye sensor may be activated and the monitor turned off unintentionally by covering the eye sensor
with the monitor or your hands. In this case, select [Auto: 1] or [Monitor(Manual)].
Related Topic
Custom Key/Dial Set.] or [
Custom Key Setting] → set [Finder/Monitor Sel.] to the preferred
426
Advertisement
Table of Contents
