Table of Contents
Advertisement
Help Guide
Interchangeable Lens Digital Camera
ILCE-9M3
α9III
Using flash (sold separately)
In dark environments, use the flash to light up the subject while shooting. Also use the flash to prevent camera-shake.
For details on the flash, refer to the instruction manual for the flash.
Attach the flash (sold separately) to the product.
1
Shoot after you have turned on the flash and it is fully charged.
2
(Charging flash icon) blinking: Charging is in progress
(Charging flash icon) lit up: Charging is finished
The available flash modes depend on the shooting mode and function.
Hint
For some flash models, flash shooting can be performed throughout the range of the shutter speed of the camera regardless of
the conventional high-speed sync (HSS) flash control setting. However, increasing the shutter speed will change the amount of
exposure from the flash-light.
Refer to the dedicated support page for details.
https://www.sony.net/dics/ilce9m3fl/
Note
The light of the flash may be blocked if the lens hood is attached and the lower part of a recorded image may be shaded. Remove
the lens hood.
You cannot use the flash when recording movies. (You can use an LED light when using a flash (sold separately) with an LED
light.)
Before attaching/removing an accessory such as a flash to/from the Multi Interface Shoe, turn off the product first. When attaching
an accessory, make sure that the accessory is fixed securely to the product.
Do not use the Multi Interface Shoe with a commercially available flash that applies voltage of 250 V or more or has the reverse
polarity of the camera. Doing so may cause a malfunction.
You can use a flash of the reverse polarity with the Sync Terminal. Please use a flash with a sync voltage of 400 V or less.
346
Advertisement
Table of Contents
