Table of Contents
Advertisement
Quick Links
Product Installation Guidelines
Capstan CP Lead Safe½ Turn Wall Top Ass Child
Safety Tap
PRODUCT CODE:
-
175.91.00.03
SPECIFICATIONS
−
The Galvin Engineering Safety Tap has been devised to add another precautionary aid against children
tampering with hot water. Once the flow is set, young children are unable to tamper with the flow until
reset by an adult.
−
The main body is made of solid dezincification resistant (DR) brass rod.
SBA's includes brass ceramic disc component, with red and blue indicator.
−
−
Lead Safe™ brass construction*
IMPORTANT: All taps are tested in accordance with AS/NZS 3718 and leave our premises in good working
order.
*As 'lead free' is not currently defined by law in Australia and New Zealand, we have based our definition of Lead Safe™ on the requirements of Sec. 1417 of the USA's Safe Drinking Water Act
(SDWA) and the relevant US standards NSF61 / NSF372. The SDWA defines 'lead free' as "not more than a weighted average of 0.25% lead when used with respect to the wetted surface of
pipes, pipe fittings, plumbing fittings and fixtures".
WARNINGS: Special attention to be paid on notes, photos, image, or drawings of assembly
steps marked with the warning symbol.
TECHNICAL DATA
Inlet
Outlet
Headwork
Working Pressure Range (kPa)
Working Temperature Range (°C)
Nominal Flow Rate (LPM)
Finish
NOTE: Galvin Engineering continually strive to improve their products. Specifications may change without
notice.
TOOLS REQUIRED
© Galvin Engineering Pty Ltd
Version 1, 7 July 2023, Page 1 of 5
G 5/8" BSP - Male
N/A
Ceramic Disc
Min
50
Max
500
Min
5
Max
65
N/A
Chrome
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Galvin Engineering Capstan 175.91.00.03
Summary of Contents for Galvin Engineering Capstan 175.91.00.03
- Page 1 SPECIFICATIONS − The Galvin Engineering Safety Tap has been devised to add another precautionary aid against children tampering with hot water. Once the flow is set, young children are unable to tamper with the flow until reset by an adult.
- Page 2 PRE-INSTALLATION - MOUNTING DETAILS Note: Before installation, all lines must be flushed. Galvin Engineering recommends the installation of strainers and pressure reducing valves to ensure clean consistent supply. Debris or poor water quality could cause the push button to seize or fail to seal.
- Page 3 Version 1, 7 July 2023, Page 3 of 5 INSTALLATION INSTALLATION COMPLIANCE: Galvin Engineering products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
- Page 4 Water is not flowing from tap debris. Install an inline strainer. Check if there are obstructions Obstruction on spout hindering the water flow in the spout and take it out. Handle is loose Screw has come loose Tighten handle screw © Galvin Engineering Pty Ltd...
- Page 5 8. Follow the product installation guidelines for the relevant product re-assembly method. WARRANTY The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Need help?
Do you have a question about the Capstan 175.91.00.03 and is the answer not in the manual?
Questions and answers