Kenwood DP-R893 Instruction Manual page 5

A Caution : Read this page carefully to ensure safe operation.
12.Carts and stands —-— An appliance and cart
combination should be moved with care. Quick stops,
excessive force, and uneven surfaces may cause the
appliance and cart combination to overturn.
13.Nonuse periods — The power cord of the unit
should be unplugged from the outlet when left un-
used for a long period of time.
14.Abnormal smell — !f an abnormal smell or smoke is
detected, immediately turn the power OFF and pull
out the power cord. Contact your dealer or nearest
service center.
POWER OFF!
15.Damage requiring service — The unit should be
serviced by qualified service personnel when:
A. The power-supply cord or the plug has been
damaged; or
B. Objects have fallen, or liquid has been spilled into
the unit; or
G. The unit has been exposed to rain; or
D. The unit does not appear to operate normally or
exhibits a marked change in performance; or
E. The unit has been dropped, or the enclosure
damaged.
16.Servicing — The user should not attempt to service
the unit beyond that described in the operating
instructions. Allother servicing should be referred to
qualified service personnel.
Notes:
1. ltem 3 is not required except for grounded or polarized equipment.
17.Outdoor antenna grounding - If an outside an
tenna is connected to the receiver, be sure the an-
tenna system is grounded so as to provide some
protection against voltage surges and built up static
charges. Section 810 of the National Electrical Code,
ANSI/NFPA 70, provides information with respect to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location
of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding
electrode. See Figure.
EXAMPLE OF ANTENNAS GROUNDING AS PER NATIONAL
ELECTRICAL CODE
ANTENNA
LEAD IN WIRE
L ANTENNA
DISCHARGE UN!T
(NEC SECTION 810-20)
p~..
GROUNDING CONDUCTORS
(NEC SECTION 870-21}
GROUND CLAMP
raat" POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NEC — NATIONAL ELECTRICAL CODE
18.Power lines - An outdoor antenna should be lo-
cated away from power lines.
19.AC outlets — Do not connect other audio equipment
with a power consumption larger than that specified
to the AC outlet on the rear panel, Never connect
other electrical units, such as an iron or toaster, to it
to prevent fire or electric shock.
2, Item 17 and 18 are not required except for units provided with antenna terminals.
3, Item 17 complies with UL in the U.S.A.
DP-R893 (En) 5