Kenwood DP-R893 Instruction Manual page 19

Specifications
Format General
SYSTOMM -orereeserecsssecetees Compact disc digital audio system POWEr CONSUMPTION «-.--+-0-serrcessecersseeseeserees eussoucsesevessr 15 W
De SOE vassrewawcucndevevceducnsivaseruvesies cuesteteude Semiconductor laser DITO NGI ONG: src sscevessvscctsncwsesssnvesseness W : 440 mm (17-5/16")
Playing rotation «-+++.+--+--.----e100 200 rpm - 500 rpm (CLV) H:120mm_ = (4-3/4")
D:390mm _ (15-3/8")
Weight (Net) o--<cerscrserccescrsseserenesseoerscutseneesone 5.4 kg (11.9 Ib)
D/A convertors
D/A CONVELSION -10sessnesscnserssascenensuesaseneeseensesanssenennanenssees 1 Bit
OVErSAMPLiNg --1+cecreesernenecccersnensoenenansasewaaarscnneenetoennssenes 8 ts
Audio
Frequency r@Sponse -------++-:-se0ersses 4 Hz ~ 20 kHz, +1.0 dB
Signal tO NOISE ratio -++-------22..eessssseseseweees more than 96 dB
DYNAMIC FANGE «11ee-erecreneseneatesseeeseevansnenen more than 94 dB
Fotal harmonic distortion ------ less than 0.008 % at 1 kHz
Wlows flutter --<::sccccccssesccsconssnsnncnnersnans »-unmeasurable limit
Output level/iMpPedance ----.-ccrssceseeeranerneneenes 2.0 V/3.3 kQ
Note:
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications."
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
—— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
DP-R893 {En} 19