Kenwood DP-R893 Instruction Manual page 3

Before applying power
For the U.S.A. and Canada
Important!
Units shipped to the U.S.A. and Canada are designed for
operation on 120 volts AC only.
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE
THE AC PLUG WITH AN EXTENSION CORD, RECEPTACLE OR
OTHER OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE. :
For the United Kingdom
Important!
Units shipped to the U.K. are designed for operation on 240
valts AC only.
The mains plug must be removed from the wall socket prior to
any interna! examination.
The wires in this mains lead are coloured in accordance with the
following code: = =
Neutral
Brow iicteiecee sans east Lie
The wires in this mains lead must be connected to the terminals
in the plug as follows:
Wire colour
BIG: cit pehersceyteaaieanas
ESCO MAI ite cordate ech eoeniowwesaecs
Plug terminal marking
ewer. NOP BlACk
eiacmacvs Or Hed
Blue to
Neutral
Plug
Notes:
1.lf a 18-amp plug is used, this must be fitted with a
13-amp fuse.
2. If a 3-pin plug with earthing contact is used, no wire must be
connected to the E terminal.
Safety precautions
A Caution: Read this page carefully to ensure safe operation.
For Australia and Europe
Important!
Units shipped to Australia are designed for operation on 240 V AC
only.
Units shipped to Europe are designed for operation on 230 V AC only.
For other countries
Important!
Units shipped to countries other than the above countries are equipped
with an AC voltage selector switch on the rear panel. Refer to the
following paragraph for the proper setting of this switch.
AC voltage selection
This unit operates on 110-120 of 220-240 volts AC. The AC voltage
selector switch Type A or Type B on the rear panel is set to the
voltage that prevails in the area to which the unitis shipped. Before
connecting the power cord to your AC outlet, make sure that the
setting position of this switch matches your line voltage. If not, it
must be set to your voltage in accordance with the following
direction.
AC voltage selector switch
te
mill
AC110- «= AC 220-
120 V ~ 240 V ~
Type A
— el
FEO piti i
mil |
Pri Pi ey
AC 110-
Move switch lever to match your line voltage with
a small screwdriver or other pointed tool.
Note: ———_—iom@®$ oem —_—
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIG SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK}. NO USER-SERVICEABLE PARTS INSIDE, REFER SER-
VICING TO QUALIFIED SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOL-
TAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE
TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE
USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) IN-
STRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.
DP-R893 (En) 3
ah