Husqvarna K 1 PACE Workshop Manual page 33

8.11.2.2 To install the bearings with a standard press
Make sure the cutter arm is level.
• Push the blade shaft bearing. Use a mandrel with
diameter 32 - 34 mm.
CAUTION: Apply grease to the gearbox.
To install the bearings with a
Refer to
standard press on page 33 .
1597 - 003 - 05.07.2023
8.11.3 To apply grease to the gearbox
CAUTION: Always apply grease to the gearbox
after you have opened it.
1. Remove the 2 screws.
2. When the gearbox is clean and empty, apply 18 ml
of grease with a grease gun.
Repair instructions - 33